Control4 UniFi: Manual Setup of UniFi Network Device
Control4 UniFi: Manual Setup of UniFi Network Device
It is strongly recommended to use Auto Setup to correctly configure and add new devices instead of Manual Setup
- Ensure that UniFi Network Controller has been added to project and is correctly configured. The UniFi Network Controller device must be successfully connected to the UniFi Network controller
- Add the UniFi Network Device driver
- In
Composer Pro Connections, ensure that that device driver is bound to
UniFi Protect Controller, and all required bindings are made
- Use Select Device From List to select the device to control
Related Articles
Control4 UniFi: Manual Setup of UniFi Protect Device
Control4 UniFi: Manual Setup of UniFi Protect Device It is strongly recommended to use Auto Setup to correctly configure and add new devices instead of Manual Setup Ensure that UniFi Protect Controller has been added to project and is correctly ...Control4 Unifi - Control4 Overwrites UniFi Intercom call group settings
When using the Chowmain UniFi Driver, the Call group table is incorrectly overwritten. By default, the UniFi Driver automatically sync's and configures the table to allow the intercom to communicate overwriting existing information Solution You MUST ...CONTROL4 UNIFI: Setup API keys correctly to avoid Error 401 / Unauthorised Error
Important Notice UniFi Access doesn't use the same API Key as UniFi Protect/Network. Keys created for Protect / Network will not work. If the incorrect key is used, you will get a 401 / Unauthorised error in API Connection Status Setting Up UniFi ...Control4 Hisense VIDAA - Device Management Menu does not show
If the Device Management menu doesn't show, take the following troubleshooting steps Ensure the TV firmware is up to date. The Device Management menu may not be available on older firmware versions. Version 9 or later is required (Under About, ...Control4 UniFi - UNVR NVR Stacking Support
At this time, UNVR Stacking is not supported by the Chowmain driver, and is strongly discouraged by Ubiquiti. Initial investigations have determined that there is limited support for stacked NVR's within the official API which affects control, and ...