HOW TO: Jump directly to Cameras on Control4 Touchscreens

HOW TO: Jump directly to Cameras on Control4 Touchscreens

Overview

In some cases such as Unifi Doorbells, and certain security events (such as Panic, Security Alarms or potentially even motion in a pool area), installers may wish to configure their Control4 system to automatically switch touchscreens, or TV's to display a camera for a set time period. 

Procedure

In Composer Pro under Agents, ensure the Navigation Agent is installed  

Under Programming, in Navigation, use the Jump To Camera command

    • Related Articles

    • Control4 Unifi: iPads / iPhone / IOS Crashes when viewing Protect Cameras

      The most common cause of IOS crashes is by third party cameras connected to the Protect system. Improved Stream Compatibility mode may be required to resolve the issue. As of 2025, this can be found in the Unifi Protect Web Administration Interface: ...

    • Control4 UniFi: Accessing Camera Recordings / Footage and Snapshots in UniFi Protect

      Summary To Access Recorded camera footage for UniFi Cameras, Chowmain have developed a custom interface for the UniFi Protect Driver which provides access. This is required as Control4 does not provide access to snapshots / video under history Setup ...

    • Control4 Unifi Protect: Accessing Camera History Snapshots and recordings

      Problem Control4 does not provide access to third party developers to attach snapshots and video to the built in Camera interface history. To provide Solution Chowmain have developed a custom NVR interface which is built into the UniFi Protect ...

    • Control4 UniFi - UNVR NVR Stacking Support

      At this time, UNVR Stacking is not supported by the Chowmain driver, and is strongly discouraged by Ubiquiti. Initial investigations have determined that there is limited support for stacked NVR's within the official API which affects control, and ...

    • ELAN Escea: Unable to Control Fireplace

      Summary Fireplace Control does not operate correctly, or information is not correct Solution Ensure Fireplace is connected by network and can be pinged. NCAPI must be enabled. This is done via the Fire Settings menu in the Escea Smartheat app. The ...