CONTROL4 BOND: How to send generic bond bridge commands
In Composer, navigate to Programming > Actions > Device Actions, and select the Bond bridge driver.
Use the bridge driver's Device Specific Command > Fire Command > COMMAND to send a command available on the Bond app that isn't available in Control4 or via our drivers (ex. tilt in a blind device has no proxy command that we can associate to it).
When you click the ... button, the list will appear empty for as long as it takes for the driver to request and receive all the commands (represented as buttons learned for each device in the Bond app) available to the bridge.
This can take up to 5 minutes if the Bond has a large amount of devices learned into it.
The list is not alphabetically ordered so, search the complete list for your preferred command
You can now assign this command to an Experience Button or other programming.
Caution
Control4's proxies are not updated when these commands are fired.
It is your responsibility to make sure the client is aware that the Control4 proxy UI will become out of sync with the physical state of the device.
Before any troubleshooting by Chowmain you must remove all commands added via this method
Related Articles
Control4 Philips Hue: Bridge Disconnected or Real Time Connection Failed
Symptoms Control4 is unable to connect to bridge or real time feedback status is disconnected Solution Connection Status Disconnected Ensure that System Requirements have been met. Ensure that Hue bridge is set to Static IP, or a static IP has been ...Control4 Philips Hue: "Select Bridge From List Property List is Empty. No Philips Hue Bridges Discovered
Symptom The "Select Bridge From List" Property is empty, and no bridges have been discovered Solutions Ensure that the Hue Bridge is powered on and connected to the network and internet The Hue bridge must be fully configured using the App and ...Control4 Hisense VIDAA: TV Turns on however does not respond to commands
The Hisense TV turns on, however does not respond to commands Solution Ensure the driver is correctly authorised Ensure the IP is correct and has been set to static. Ensure that there are no IP conflicts with other devices and that Control4 can ...Control4 Hisense VIDAA: TV control is erratic
TV Control only works intermittently Solution Ensure that CEC is disabled on the TV. CEC can interfere with control particularly when devices power on or off Check the stability of the network connection. A wired connection is recommended for best ...Control4 Philips Hue: Manual Setup of Hue Device / Light
Control4 Philips Hue: Manual Setup of Hue Device / Light It is strongly recommended to use Auto Setup to correctly configure and add new devices instead of Manual Setup Ensure that Philips Hue bridge has been added to project and is correctly ...