Control4 Hisense VIDAA: Volume Control shows incorrect volume

Control4 Hisense VIDAA: Volume Control shows incorrect volume

Problem

The Volume Control shows incorrect volume

Solution

  1. Ensure that the latest TV firmware is installed
  2. Ensure that you are using Driver version 20250910 or later 
  3. Discrete volume control may not be supported correctly when using ARC and is generally only properly supported when using the internal TV speakers. If using external speakers, it is recommended to instead control the speakers directly
 

    • Related Articles

    • Control4 Hisense VIDAA: TV control is erratic

      TV Control only works intermittently Solution Ensure that CEC is disabled on the TV. CEC can interfere with control particularly when devices power on or off Check the stability of the network connection. A wired connection is recommended for best ...

    • Control4 Hisense VIDAA - Device Management Menu does not show

      If the Device Management menu doesn't show, take the following troubleshooting steps Ensure the TV firmware is up to date. The Device Management menu may not be available on older firmware versions. Version 9 or later is required (Under About, ...

    • Control4 Hisense VIDAA: Initial Setup

      Setup Instructions For TV Turn on Hisense VIDAA TV. Configure TV Channels and settings as required. Ensure the TV is accessible from the same network as the Control4 system. Update the TV firmware to the latest version if necessary. This is normally ...

    • Control4 Hisense VIDAA: System Requirements

      Requirements Only the Hisense VIDAA Platform is supported by the Chowmain Driver. Hisense TV's using Android or other platforms use a different unsupported protocol Control4 OS 3.3.0 or higher. OS3.4.X or later is recommended. X4 is supported ...

    • Control4 Hisense VIDAA: TV Turns on however does not respond to commands

      The Hisense TV turns on, however does not respond to commands Solution Ensure the driver is correctly authorised Ensure the IP is correct and has been set to static. Ensure that there are no IP conflicts with other devices and that Control4 can ...